[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: [ST] Valve Job
What site? Our site? Where?
-----Original Message-----
From: st-bounces@xxxxxxxxxxxxxxxxxxxx
[mailto:st-bounces@xxxxxxxxxxxxxxxxxxxx]On Behalf Of Rik Relph
Sent: Friday, January 13, 2006 1:39 PM
To: ST@xxxxxxxxxxxxxx
Subject: Re: [ST] Valve Job
There is a drawing available on this site.
I made my own.
Cost me about £8.20 if I remember.
Rik.
Cambridge, ENGLAND.
FXDWG
'02 ST
-----Original Message-----
From: st-bounces@xxxxxxxxxxxxxxxxxxxx
[mailto:st-bounces@xxxxxxxxxxxxxxxxxxxx] On Behalf Of Masiak, Richard
Sent: 13 January 2006 18:26
To: ST@xxxxxxxxxxxxxx
Subject: [ST] Valve Job
Has anyone out there done their own valve job? The tool the manual
specifies is T3880012 at about $130.
Now I know "non-dealer" shops can perform this service on our bikes, so
there must be a generic tool they use that can handle a valve on top setup.
I doubt they'll buy a tool for every different model bike they service.
Where can I find a less expensive tool to accomplish the same thing? Ideas?
Rich
00 RS
_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com
_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com
_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com