[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: Engine Management Light
- Subject: Re: Engine Management Light
- From: Eric Sheley <eric@xxxxxxxxxx>
- Date: Fri, 14 Apr 2000 16:20:05 -0400
This may not work though as many errors take 3 or more warm-up cycles to
reset the light - so just turning it on and off three times will not cause
the light to go out. Best bet is just to have the dealer read the code.
- - Eric
At 04:05 PM 4/14/00 -0400, Erik Miner wrote:
>You might want to try cycling the computer. Turn the bike on with the
>key only, do not use the kill switch. Wait a couple of seconds to
>let the fuel build, start the bike let it idle for a minute then shut
>it off USING THE KEY ONLY no kill switch. Now start the bike again
>same way, key only and see if the check engine light remains on. If
>so them you prolly do have some sort of management fault.
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=