Re: RCS+ for Sigma BC800

[Eric Sheley <eric@xxxxxxxxxx>]

At 01:28 PM 8/11/00 -0700, Neil Lindsey wrote:
>Has anyone successfully used the wireless option in conjunction with their
>BC800 and a motorcycle?
>I'm told that the range on the xmit/recv is limited, and suspect that engine
>interference and potential blockage of 'line-of-sight' represent problems
>that may not have been addressed in the design of the unit .  Sure would be
>a clean installation though, and I could still use the unit on my mountain
>bike.  Has anyone tried?

The RCS+ limits measurement to 99mph. Other than that it works fine. You 
would be limited in mounting locations, the receiver takes up more room, 
and now you have two batteries to worry about.

>   Did anyone run into problems dealing with the
>relatively short length of wire between the BC800 mounting bracket and the
>sensor?

Mine was pretty close to the limit, so I purchased the rear wheel sensor 
kit, which gives you a longer wire. No problems then....

- - Eric


     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=